EasyManua.ls Logo

R&S RTO6 - Page 231

R&S RTO6
2677 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Triggers
R&S
®
RTO6
231User Manual 1801.6687.02 ─ 05
"A Zone"
Triggers if the conditions of the A-event and the zone trigger are fulfil-
led. A holdof
f condition also can be set.
"A
B R
Zone"
Triggers if all conditions of A- and B-events, reset timeout or R-event
(reset) conditions are fulfilled for the defined zone.
"A OR B"
Triggers if the conditions of A-event or the conditions of the B-event
are fulfilled.
"A OR B
Zone"
Triggers if the conditions of A-event or the conditions of the B-event
are fulfilled for the defined zone. A holdof
f condition also can be set.
Remote command:
TRIGger<m>:
SEQuence:
TYPE on page 1427
After 1st event wait
Sets the time that the instrument waits after an A-trigger until it recognizes B-triggers.
Remote command:
TRIGger<m>:SEQuence:DELay on page 1428
2nd event count
Sets the number of B-trigger conditions to be fulfilled after an A-trigger. The last B-trig-
ger causes the trigger event.
The waiting time for B-triggers can be restricted with a reset condition: timeout or reset
event.
Remote command:
TRIGger<m>:SEQuence:COUNt on page 1428
Reset on event/Reset event
If enabled, the trigger sequence is restarted by the R-trigger condition if the specified
number of B-triggers does not occur before the trigger conditions are fulfilled.
The R-trigger condition is configured in the same way as the A-trigger. The instrument
disables settings that do not fit the previous settings in the sequence.
Remote command:
TRIGger<m>:SEQuence:RESet:EVENt on page 1428
Reset on timeout/Reset timeout
If timeout is enabled, the instrument waits for the "Timeout" time for the specified num-
ber of B-triggers. If no trigger occurs during that time, the sequence is restarted with
the A-trigger.
Remote command:
TRIGger<m>:SEQuence:RESet:TIMeout[:ENABle] on page 1429
TRIGger<m>:SEQuence:RESet:TIMeout:TIME on page 1429
Couple sequence thresholds
Sets the trigger levels to the values of the latest configured trigger condition. Each
channel has its own trigger level.
Sequence

Table of Contents

Other manuals for R&S RTO6

Related product manuals