R&S RTO6 - Page 2505

Remote control commands
R&S
®
RTO6
2505User Manual 1801.6687.02 ─ 05
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:RESult:VERTical:JSContinuous <State>
If enabled, the measurement scale of the jitter spectrum is set automatically.
If disabled you can manually set a ADVJitter<m>:
RESult:COMPonents<n>:
SCALe and a ADVJitter<m>:RESult:COMPonents<n>:OFFSet.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:RESult:VERTical:NHContinuous <State>
If enabled, the measurement scale of the noise histogram and track is set automati-
cally.
If disabled you can manually set a ADVJitter<m>:
RESult:COMPonents<n>:
SCALe and a ADVJitter<m>:RESult:COMPonents<n>:OFFSet.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:RESult:VERTical:NSContinuous <State>
If enabled, the measurement scale for the noise spectrum is set automatically.
If disabled you can manually set a ADVJitter<m>:
RESult:COMPonents<n>:
SCALe and a ADVJitter<m>:RESult:COMPonents<n>:OFFSet.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:RESult:COMPonents<n>:SCALe <Scale>
Sets the scale for the selected component.
Jitter analysis and clock data recovery