R&S RTO6 - Page 508

Protocol analysis
R&S
®
RTO6
508User Manual 1801.6687.02 ─ 05
"Address and
data"
Searches for a combination of address and data conditions.
Remote command:
SEARch:
TRIGger:I2C:
SCONdition on page 1693
SEARch:TRIGger:I2C:RCONdition on page 1693
SEARch:TRIGger:I2C:STCNdition on page 1694
SEARch:TRIGger:I2C:NACKnowledge on page 1694
SEARch:TRIGger:I2C:SADDress on page 1694
SEARch:TRIGger:I2C:ADOR on page 1695
SEARch:TRIGger:I2C:ADData on page 1695
Address setup: Condition, Type, Addr. min, Addr. max, R/W bit
The address setup consists of the condition, type, R/W bit and one or two address pat-
terns.
The address setup settings are the same as in the I2C trigger setup, see "Address"
on page 503.
Remote command:
SEARch:TRIGger:I2C:ACONdition on page 1695
SEARch:TRIGger:I2C:ADDRess on page 1696
SEARch:TRIGger:I2C:ADDTo on page 1696
SEARch:TRIGger:I2C:AMODe on page 1696
SEARch:TRIGger:I2C:ACCess on page 1697
Data setup: Condition, Position, Index min, Index max, Value min, Value max
The data setup consists of the condition, position, and one or two index/value patterns.
The data setup settings are the same as in the I2C trigger setup, see "Data"
on page 504.
Remote command:
SEARch:TRIGger:I2C:DPOPerator on page 1698
SEARch:TRIGger:I2C:DPOSition on page 1699
SEARch:TRIGger:I2C:DPTO on page 1699
SEARch:TRIGger:I2C:DCONdition on page 1699
SEARch:TRIGger:I2C:DMIN on page 1700
SEARch:TRIGger:I2C:DMAX on page 1700
Address OR setup: , OR x Address type, Address, R/W bit
The address OR setup consists of the monitor, address type, address and an R/W bit.
The address OR setup settings are the same as in the I2C trigger setup, see Chap-
ter 13.2.3.1, "I²C trigger settings", on page 499.
Remote command:
SEARch:TRIGger:I2C:ADDO<m>:ENABle on page 1697
SEARch:TRIGger:I2C:ADDO<m>:ADRType on page 1697
SEARch:TRIGger:I2C:ADDO<m>[:VALue] on page 1698
SEARch:TRIGger:I2C:ADDO<m>:RWBit on page 1698
I²C (option R&S R
T
O6-K510)