R&S RTO6 - Page 645

Protocol analysis
R&S
®
RTO6
645User Manual 1801.6687.02 ─ 05
"Error condition"
Triggers if certain errors occur.
Y
ou can select the following error events for triggering:
●
"Form Error"
●
"Calibration Pulse Error"
●
"Pulse Period Error"
●
"CRC Error"
●
"Irregular Frame Length Error"
Description of error-specific trigger conditions, see "Error conditions
setup"
on page 648.
Remote command:
TRIGger<m>:
SENT:
TYPE on page 1903
Transmission Sequence setup
Configures the trigger conditions for trigger type transmission sequence.
Note: The displayed parameters depend on the selected "Sequence"
. The instrument
displays the data setting parameters when you select "Status+Data", see "Type"
on page 643.
Sequence ← Transmission Sequence setup
Selects the condition for triggering in a single transmission sequence.
You can trigger on the end of the status nibble or the combination of the status and
data nibbles.
Remote command:
TRIGger<m>:
SENT:TTYPe on page 1904
Status ← Transmission Sequence setup
Defines the data bits for the status nibble.
Remote command:
TRIGger<m>:SENT:STATus on page 1904
Condition ← Transmission Sequence setup
Selects the operator to define a specific data pattern or a data range.
SENT (option R&S RT
O6-K520)