EasyManua.ls Logo

R&S RTO6 - Page 837

R&S RTO6
2677 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protocol analysis
R&S
®
RTO6
837User Manual 1801.6687.02 ─ 05
"Condition"
Defining a specific endpoint or an endpoint range requires to set the
operator to one of the following: equal, not equal, less than, less than
or equal, greater than, greater than or equal, in range, out of range.
"Min"
Specifies an endpoint, or sets the start value of an endpoint range.
"Max"
Sets the end value of an endpoint range if "Condition" (SEARch:
TRIGger:USB:ECONdition) is set to
INRange or OORange.
Remote command:
SEARch:TRIGger:USB:
WEND on page 2181
SEARch:TRIGger:USB:ECONdition on page 2172
SEARch:TRIGger:USB:EMIN on page 2173
SEARch:TRIGger:USB:EMAX on page 2173
Frame number check
Enables the search for a frame number that meets specific conditions.
"Condition"
Defining a specific frame number or a frame number range requires
to set the operator to one of the following: equal, not equal, less than,
less than or equal, greater than, greater than or equal, in range, out
of range.
"Min"
Specifies a frame number, or sets the start value of a frame number
range.
"Max"
Sets the end value of a frame number range if "Condition" (SEARch:
TRIGger:USB:FCONdition) is set to INRange or OORange.
Remote command:
SEARch:TRIGger:USB:
WFRN on page 2181
SEARch:TRIGger:USB:FCONdition on page 2173
SEARch:TRIGger:USB:FMIN on page 2173
SEARch:TRIGger:USB:FMAX on page 2174
Payload check
Enables the search for a payload data pattern that meets specific conditions.
"Condition"
Sets the operator "any" or "equal" that allows to search for payload
data at any position or at a specified position.
"Position"
Available only if "Condition" (SEARch:TRIGger:USB:
DPOPerator)
is set to equal. Specifies the position in which a special data pattern
is to be searched within the payload data packet.
"Data Condi-
tion"
Sets the operator ("equal" or "unequal", SEARch:TRIGger:USB:
DCONdition) to set a specific payload data pattern.
"Payload pat-
tern"
Specifies the payload data pattern that is to be searched.
Remote command:
SEARch:TRIGger:USB:
WPAY on page 2181
SEARch:TRIGger:USB:DPOPerator on page 2171
SEARch:TRIGger:USB:DPOSition on page 2172
SEARch:TRIGger:USB:DCONdition on page 2171
SEARch:TRIGger:USB:PATT on page 2174
USB (option R&S RT
O6-K570)

Table of Contents

Other manuals for R&S RTO6

Related product manuals