R&S RTO6 - Page 243

Waveform analysis
R&S
®
RTO6
243User Manual 1801.6687.02 ─ 05
X start ← Start/Stop
Defines the lower limit of the zoom area on the x-axis.
Remote command:
LAYout:
ZOOM:HORZ:
ABSolute:STARt on page 1440
LAYout:ZOOM:HORZ:RELative:STARt on page 1442
X stop ← Start/Stop
Defines the upper limit of the zoom area on the x-axis.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:STOP on page 1441
LAYout:ZOOM:HORZ:RELative:STOP on page 1442
Y start ← Start/Stop
Defines the lower limit of the zoom area on the y-axis.
Remote command:
LAYout:ZOOM:VERTical:RELative:STARt on page 1445
LAYout:ZOOM:VERTical:ABSolute:STARt on page 1444
Y stop ← Start/Stop
Defines the upper limit of the zoom area on the y-axis.
Remote command:
LAYout:ZOOM:VERTical:RELative:STOP on page 1445
LAYout:ZOOM:VERTical:ABSolute:STOP on page 1444
Position/Range
In the "Position/Range" tab, you specify the x and y position of center point of the zoom
area plus a range for the x- and y-axes; the area defined by that point and the ranges
is zoomed.
X position ← Position/Range
Defines the x-value of the centerpoint of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:
ABSolute:POSition on page 1439
LAYout:ZOOM:HORZ:RELative:POSition on page 1441
SEARch:RESDiagram:HORZ:ABSolute:POSition on page 1634
SEARch:RESDiagram:HORZ:RELative:POSition on page 1635
Zoom