R&S RTO6 - Page 306

Measurements
R&S
®
RTO6
306User Manual 1801.6687.02 ─ 05
"Relative"
The gate's start and stop values are defined by a percentage of the
value range.
Remote command:
CALCulate:MATH<m>:
FFT:GATE:MODE on page 1573
MEASurement<m>:GATE:MODE on page 1547
SEARch:GATE:MODE on page 1632
(Relative) Start
Defines the starting value for the gate.
Remote command:
CALCulate:MATH<m>:FFT:GATE:ABSolute:STARt on page 1573
CALCulate:MATH<m>:FFT:GATE:RELative:STARt on page 1574
MEASurement<m>:GATE:ABSolute:STARt on page 1547
MEASurement<m>:GATE:RELative:STARt on page 1547
SEARch:GATE:ABSolute:STARt on page 1632
SEARch:GATE:RELative:STARt on page 1633
(Relative) Stop
Defines the end value for the gate.
Remote command:
CALCulate:MATH<m>:FFT:GATE:ABSolute:STOP on page 1573
CALCulate:MATH<m>:FFT:GATE:RELative:STOP on page 1574
MEASurement<m>:GATE:ABSolute:STOP on page 1547
MEASurement<m>:GATE:RELative:STOP on page 1547
SEARch:GATE:ABSolute:STOP on page 1632
SEARch:GATE:RELative:STOP on page 1633
Zoom
Zoom coupling is available if a zoom is defined. As long as
"Zoom coupling"
is
enabled, the gate area is defined identically to the zoom area - if you change the zoom,
the gate changes as well.
If several zoom diagrams are defined, select the zoom diagram to be used for gating.
The "Start" and "Stop" values of the gate are adjusted accordingly.
Zoom coupling can be set for measurement gates, FFT gates, and search gates. The
zoom must be defined on the diagram that contains the signal source of the measure-
ment, FFT, or search.
Remote command:
MEASurement<m>:GATE:ZCOupling on page 1548
MEASurement<m>:GATE:ZDIagram on page 1549
CALCulate:MATH<m>:FFT:GATE:ZCOupling on page 1574
SEARch:GATE:ZCOupling on page 1633
SEARch:GATE:ZDIagram on page 1634
Cursor
If enabled, the gate area is defined by the cursor lines of an active cursor measure-
ment.
Automatic measurements