EasyManua.ls Logo

R&S RTO6 - Page 829

R&S RTO6
2677 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protocol analysis
R&S
®
RTO6
829User Manual 1801.6687.02 ─ 05
Remote command:
TRIGger<m>:
USB:ERRC
on page 2155
PID error
Defines, whether a packet ID error check is executed or not.
Remote command:
TRIGger<m>:USB:WPID on page 2162
End Point
Defines, whether an endpoint check that meets specific conditions is executed or not.
"Condition"
Defining a specific endpoint or an endpoint range requires to set the
operator to one of the following: equal, not equal, less than, less than
or equal, greater than, greater than or equal, in range, out of range.
"Min"
Specifies an endpoint, or sets the start value of an endpoint range.
"Max"
Sets the end value of an endpoint range if "Condition"
(TRIGger<m>:USB:ECONdition) is set to
INRange or OORange.
Remote command:
TRIGger<m>:USB:WEND
on page 2161
TRIGger<m>:USB:ECONdition on page 2155
TRIGger<m>:USB:EMIN on page 2155
TRIGger<m>:USB:EMAX on page 2155
Address
Defines, whether an address check that meets specific conditions is executed or not.
"Condition"
Defining a specific address or an address range requires to set the
operator to one of the following: equal, not equal, less than, less than
or equal, greater than, greater than or equal, in range, out of range.
"Min"
Specifies an address, or sets the start value of an address range.
"Max"
Sets the end value of an address range if "Condition" (TRIGger<m>:
USB:ACONdition) is set to INRange or
OORange.
Remote command:
TRIGger<m>:USB:WADD
on page 2161
TRIGger<m>:USB:ACONdition on page 2153
TRIGger<m>:USB:AMAX on page 2153
TRIGger<m>:USB:AMIN on page 2153
Payload
Defines, whether a payload check that meets specific conditions is executed or not.
"Condition"
Sets the operator "any" or "equal" that allows to trigger for payload
data at any position or at a specified position.
"Position"
Available only if "Condition" (TRIGger<m>:USB:DPOPerator) is set
to
equal. Specifies the position in which a special data pattern is to be
triggered within the payload data packet.
"Data Condi-
tion"
Sets the operator ("equal" or "unequal", TRIGger<m>:USB:
DCONdition) to set a specific payload data pattern.
USB (option R&S RT
O6-K570)

Table of Contents

Other manuals for R&S RTO6

Related product manuals