Protocol analysis
R&S
®
RTO6
830User Manual 1801.6687.02 ─ 05
"Payload pat-
tern"
Specifies the payload data pattern that is to be triggered.
Remote command:
TRIGger<m>:
USB:WPAY
on page 2161
TRIGger<m>:USB:DPOPerator on page 2154
TRIGger<m>:USB:DPOSition on page 2154
TRIGger<m>:USB:DCONdition on page 2154
TRIGger<m>:USB:PATT on page 2157
Frame number
Defines, whether a frame number check that meets specific conditions is executed or
not.
"Condition"
Defining a specific frame number or a frame number range requires
to set the operator to one of the following: equal, not equal, less than,
less than or equal, greater than, greater than or equal, in range, out
of range.
"Min"
Specifies a frame number, or sets the start value of a frame number
range.
"Max"
Sets the end value of a frame number range if "Condition"
(TRIGger<m>:USB:FCONdition) is set to INRange or OORange.
Remote command:
TRIGger<m>:USB:WFRN
on page 2161
TRIGger<m>:USB:FCONdition on page 2156
TRIGger<m>:USB:FMIN on page 2156
TRIGger<m>:USB:FMAX on page 2157
SC
Defines, whether a Start / Complete SPLIT transaction check is executed or not.
Remote command:
TRIGger<m>:USB:WSTC on page 2162
TRIGger<m>:USB:STCO on page 2159
Port
Defines, whether a port check that meets specific conditions is executed or not.
"Condition"
Defining a specific port number or a port number range requires to
set the operator to one of the following: equal, not equal, less than,
less than or equal, greater than, greater than or equal, in range, out
of range.
"Min"
Specifies a port number, or sets the start value of a port number
range.
"Max"
Sets the end value of a port number range if "Condition"
(TRIGger<m>:USB:PCONdition) is set to
INRange or OORange.
Remote command:
TRIGger<m>:USB:WPOR
on page 2162
TRIGger<m>:USB:PCONdition on page 2157
USB (option R&S RT
O6-K570)
To Next Page
Loading...
