R&S RTO6 - Page 662

Protocol analysis
R&S
®
RTO6
662User Manual 1801.6687.02 ─ 05
"Serial Message"
Searching on a serial message depends on the serial protocol
selected with Serial protocol
> Short | Enhanced
and the associated
setting parameters:
●
"Sequence > Identifier": searches for the end of the identifier nib-
ble.
●
"Sequence > ID+Data": searches for the end of the "ID and Data"
nibble.
Description of the serial messages specific settings: "Serial Message
setup" on page 663
"Error Condition"
Searches for the end of certain error events.
Description of trigger type specific settings: "Error conditions setup
"
on page
664
Remote command:
SEARch:TRIGger:SENT:
CALibration on page 1917
SEARch:TRIGger:SENT:TRANsmission on page 1917
SEARch:TRIGger:SENT:SMSG on page 1917
SEARch:TRIGger:SENT:ERRor on page 1918
Transmission Sequence setup
Configures the search conditions for the transmission sequence.
Note: The displayed parameters depend on the selected
"Sequence"
. The instrument
displays the data setting parameters when you select "Status+Data", see "Sequence"
on page 662.
The search type specific conditions are the same as for the trigger type, see "Trans-
mission Sequence setup" on page 645.
Sequence ← Transmission Sequence setup
Selects the condition for searching in a single transmission sequence.
You can search for the end of the status nibble or the combination of the status and
data nibble(s).
Remote command:
SEARch:TRIGger:SENT:TTYPe on page 1918
Status ← Transmission Sequence setup
Defines the data bits for the status nibble.
Remote command:
SEARch:TRIGger:SENT:STATus on page 1919
Condition ← Transmission Sequence setup
Selects the operator to define a specific data pattern or a data range.
The available operators:
●
Equal, Not equal
●
Less than, Greater than
●
Less or equal, Greater or equal
●
In range, Out of range
SENT (option R&S R
T
O6-K520)