1/05
8a-19
DocuColor 12/DCCS50
REP 2.7.7, REP 2.7.8
High Capacity Feeder
Reissue
Figure 5 Positioning the Cables in the correct position
2. Reconnect the Cable Ends to the Shaft refer to (Figu
re 2).
NOTE: Position the Long Cable to the rear of the short cable on the two pulleys.
3. Manually rotate the drive shaft to check that the eleva
tor plate raises and lowers evenly
and without interference.
REP 2.7.8 HCF Brake
Parts List on PL 15.3
Removal
WARNING
To avoid electrical shock, switch-OFF the Main Power Switch and disconnect the Power
Cord.
1. Pull open the HCF Drawer.
2. Remove the HCF Brake (Figur
e 1).
Figure 1 Removing the HCF Brake
Replacement
1. Reverse the above procedures to replace the HCF Brake.
Cable guides
Long cable
Short cable
Remove the screws (2) while
holding Brake
To Next Page
Loading...
Need help?
General
