Xerox DocuColor 12/DCCS50 User Manual

1/05
4-38
DocuColor 12/DCCS50
REP 2.16.1, REP 2.16.2
Reissue
Repairs and Adjustments
REP 2.16.1 Pre Regi. Sensor
Parts List on PL 2.16
Removal
WARNING
Turn power off and disconnect the power plug.
1. Open the Front Door.
2. Remove the Regi. Unit (REP 2.14.
1).
3. Remove the Pre-Regi. Sensor with the bracket (Figu
re 1).
1. Remove the screw.
2. Remove the bracket.
3. Disconnect the connector.
4. Remove the wire from the edge saddle.
Figure 1 Removing the Pre-Regi. Sensor
Installation
1. Reinstall the parts in the reverse order of disassembly.
REP 2.16.2 Pre Regi. Roll
Parts List on PL 2.16
Removal
WARNING
Turn power off and disconnect the power plug.
1. Open the Front Door.
2. Remove the Regi. Unit (REP 2.14.
1).
3. Lower the chute (Figure
1).
1. Remove the screw.
2. Remove the coupling.
3. Remove the screws (2).
4. Lower the chute.
Figure 1 Lowering the Chute
4. Remove the Pre-Regi. Roll (Figure 2).
1.
Remove the E-clip.
2. Move the bearing in the direction of the arrow.
3. Remove the Pre-Regi. Roll.
manuals4you.commanuals4you.com

Xerox DocuColor 12/DCCS50 Specifications

General

Brand	Xerox
Model	DocuColor 12/DCCS50
Category	All in One Printer
Language	English