1/05
4-20
DocuColor 12/DCCS50
REP 2.6.1
Reissue
Repairs and Adjustments
REP 2.6.1 Feed Lift Motor
Parts List on PL 2.6
Removal
NOTE: This page describes how to remove the Tray 1Feed Lift Motor.
WARNING
Turn power off and disconnect the power plug.
1. Pull out the Tray 1 Feeder (REP 2.
4.1).
2. Remove the bracket (Figu
re 1).
1. Remove the screws (4).
2. Remove the screws (2).
3. Remove the E-clip and bearings.
4. Remove the bracket.
Figure 1 Removing the Bracket
3. Remove the Feed Lift Motor (Fi
gu
re 2).
1. Remove the screws (2).
2. Remove the Feed Lift Motor.
3. Disconnect the connector.
Figure 2 Removing the Feed Lift Motor
Installation
NOTE: Do not mistake the solenoid mounting screw for the bracket mounting screw.
1. Reinstall the parts in the reverse order of disassembly.
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
