1/05
4-120
DocuColor 12/DCCS50
REP 8.3.1, REP 8.3.2
Reissue
Repairs and Adjustments
Figure 7 Lock the Heat Roll
CAUTION
After closing the Upper Frame Assembly, ensure that the two load springs are located correctly
at each end of t
he Donor Roll Assembly, The springs may become loose during service.
1. Reinstall the parts in the reverse order of disassembly.
2. Perform the Standard Fuser Break-In Procedure (GP
1 Fuser Break-In Procedure).
3. Perform the Fuser Nip Adjustment (ADJ 8.1.
1).
REP 8.3.2 Heat Roll Heater Rod
Parts List on PL 8.3
Removal
WARNING
Turn power off and disconnect the power plug.
CAUTION
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
CAUTION
Do not touch the glass surface of the Heater Rod. I
f t
he glass surface is accidentally touched,
wipe it with a dry cloth.
1. Open the Front Door.
2. Remove the Fuser Unit (REP 8.1.
1).
3. Remove the Front Cover (PL 8.
1).
4. Remove the bracket (Figur
e 1).
1. Release the clamp and remove the wire.
2. Remove the wire from the saddle edge.
3. Disconnect the connector.
4. Remove the screw.
5. Remove the bracket.
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
