Xerox DocuColor 12/DCCS50 User Manual

1/05
8d-102
DocuColor 12/DCCS50
REP 15.2.25, REP 15.2.26
Reissue
Finisher/Sorter
Replacement
1. Reinstall the Exit Roll.
2. Reinstall the Exit Roll front and rear bearings into the bearing cutouts at the front and rear
of th
e finisher frame. Use an E-ring at both ends of the Shaft.
3. Reinstall the Exit Shaft Pulley onto the Exit Shaft, and use one screw to secure the Pulley
to the
Shaft.
4. Ensure the Transport Motor Drive Belt is properly installed on all pulleys.
5. Loosen the screws that secures the Belt Tension Assembly.
6. Allow the assembly to properly tension the
belt, then tighten the two screws.
7. Reinstall the Paddle Shaft Drive Gear and use the E-ring to secure the Gear to the Shaft.
8. Reinstall the Upper Exit Chute Assembly.
9. Reinstall the Eject Pinch Roll Assembly.
10. Reinstall the Compiler Cover Assembly.
11. Reinstall the Rear Lower Cover.
12. Reinstall the Stapler Cover Assembly.
REP 15.2.26 Compiler Paddle Shaft Assembly
Parts List on PL 18.14
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Cover Assembly (REP 15.3.
3).
3. Remove the Rear Lower Cover (REP 1
5.3.15).
4. Remove the Compiler Cover Assembly (REP 15.2.
22).
5. Remove the Eject Pinch Roll Shaft Assembly (REP 15.2.
23).
6. Remove the Upper Exit Chute Assembly (REP 15.2.
24).
7. Remove the Exit Roll (REP 15.2.
21).
8. Remove the Compiler Paddle Shaft Assembly (Figure 1
).
1. Remove the E-ring securing the rear bearing to the
Paddle Drive Shaft, and slide the
bearing off the Shaft.
2. Remove the screws (2) securing the Lower Exit Chute Assembly to the rear of the
Finis
her frame.
3. Remove the screws (2) securing the Lower Exit Chute Assembly to the front of the
Finis
her frame.
4. Remove the Lower Exit Chute Assembly and pl
ace it on a stable work surface.
5. Remove the E-rings from both ends of the Paddle Shaft.
6. Slide the Paddle Drive Belt off
of the Paddle Drive Pulley.
7. Slide the Paddle Drive Pulley off of the Paddle Shaft.
8. Remove the screw securing the front Paddle Bearing, and slide the bearing off of the
Shaft.
9.
Remove the screw securing the rear Paddle Bearing,
and remove the bearing, Drive
Belt, Drive Shaft, and Paddle Shaft from the Lower Exit Chute Assembly.
10. Slide the Paddle Shaft out of the rear bearing.
manuals4you.commanuals4you.com

Xerox DocuColor 12/DCCS50 Specifications

General

Brand	Xerox
Model	DocuColor 12/DCCS50
Category	All in One Printer
Language	English