Xerox DocuColor 12/DCCS50 User Manual

1/05
8d-90
DocuColor 12/DCCS50
REP 15.2.14
Reissue
Finisher/Sorter
REP 15.2.14 End Wall Open Sensor
Parts List on PL 18.16
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Disconnect the Finisher from the Printer.
3. Remove the Stapler Cover Assembly (REP 15.3.
3).
4. Remove the Rear Lower Cover (REP 15.3.
15).
5. Remove the Stacker Tray Assembly (REP 15.2.
2).
6. Remove the screws (4) securing the Tie Plate to the Finisher frame (Figu
re 1). Remove
the Tie Plate.
7. Remove the End Wall Open Sensor (Figure 1).
1.
Remove the screw (1) securing the Compiler Paper Sensor Bracket to the Compiler.
Remove
the Bracket along with the Compiler Paper Sensor.
2. Disconnect P/J10
46 from the Sensor.
3. Press in and release the Sensor latches that are securing the Sensor to the Bracket.
Remove t
he Sensor.
Figure 1 Remove the End Wall Open Sensor
Replacement
1. Reconnect P/J1046 to the Sensor.
2. Position the End Wall Open Sensor into the Sensor cut
out in the Sensor Bracket.
3. Reinstall the Tie Plate and use the screws (4) to secure it to the frame.
4. Reinstall the Stacker Tray Assembly.
5. Reinstall the Rear Lower Cover.
6. Reinstall the Stapler Cover Assembly.
7. Connect the Finisher to the Printer.
manuals4you.commanuals4you.com

Xerox DocuColor 12/DCCS50 Specifications

General

Brand	Xerox
Model	DocuColor 12/DCCS50
Category	All in One Printer
Language	English