To Next Page

To Previous Page

1/05

2-134

DocuColor 12/DCCS50

9-667 VH/VM Out Of Range RAP

Reissue

Status Indicator RAPs

9-667 VH/VM Out Of Range RAP

The selected LD value was out of range.

Initial Actions

• Refer to BSD 9.1 and BSD 9.15 for the following procedure.

• Clean the ESV Sensor.

• Check that P/J141 on th

e ESV Sensor, and P/J422A on the IOT Drive PWB are firmly

connected.

Procedure

Perform the following in the order listed.

• Go to the IQ 38 Charge Corotron HVP

S RAP and check the Charge Corotron HVPS for

proper operation.

• Ensure that the Charge Corotron Wire and Grid are in good condition.

•Go to Flag

6 and Flag 7 on BSD 9.1. Check the wires for an open circuit or a short circuit.

If the wires are good, replace the ESV Sensor (PL 5.1). If the problem continues, replace

the IOT Drive PWB (PL 9.2).

• If the fault was declared during the VH portion of

dC9

33, replace the Xerographic Module

(Drum CRU) (Machine Consumables, Section 6).

If the fault was declared during the VM portion of dC933, replace the ROS Assembly (PL

4.1).

manuals4you.commanuals4you.com

Xerox DocuColor 12/DCCS50 User Manual

Questions and Answers: