1/05
6-8
DocuColor 12/DCCS50
GP 6 Verifying the Auditron Password
Reissue
General Procedures
GP 6 Verifying the Auditron Password
This procedure will enable the CSE to read a machine Auditron password if the SA has forgot-
ten their password or if the SA is unavailable.
CAUTION
Use this procedure only t
o read the password resident on the machine. Then use the pass-
word to access the Auditron Administrator Screen and change the password using the normal
procedure.
Procedure
1. Enter the Service Diagnostics Mode, refer to: Entering the Service Diagnostic Mode
using the PWS
2. Select Adju
stments in the Service Entry Screen.
3. The system displays one of the Read/Write Screens. dC131 NVM Read/Write is the
default s
creen.
4. Select Other
from the Vertical Left Tab List.
5. The system displays one of the Read/Write Screens. dC131 NVM Read/Write is the
default s
creen.
6. Record and Retain NVM Values for the following locations:
• 850-001
• 850-002
• 850-003
• 850-004
• 850-005
• 850-006
• 850-007
Exiting from the Auditron Password
1. Exit from dC
13
1 NVM Read/Write Mode.
2. Exit the Dia
gnostic Mode.
3. Using the PWS, go to Pro
grams/Accessories/Scientific Calculator (This is the stan-
dard accessory in Microsoft Windows)
a. Calculator has two operating modes, select Scien
tific Format. To do this, on the
calculator icon, go to “View” and click Scientific.
b. Make sure the “Decimal” and the “Deg” formats are selected.
c. Enter dec
imal number.
4. Convert the numbers recorded from the list above t
o hexadecimal (Select Dword on cal-
culator)
a. Click the Hex form
at. This will leave you with a pair of two digit hex words.
5. Convert the hexadecimal numbers to their ASCII code equivalent. Refer to Table 1.
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
