1/05
6-11
DocuColor 12/DCCS50
GP 7 Verifying Tools Mode Password, GP 8 IDFE
General Procedures
Reissue
GP 7 Verifying Tools Mode Password
Entering, exiting and changing the Tools Mode Password.
Procedure
Entering Tool Mode
NOTE: You can use the default password (11111) to
enter the Tools mode the first time.
1. Press the Admin
istration button on the Control Panel.
2. Select the Tools but
ton on the Touch Screen.
3. Use the keypad to key-in the password (default is 11111).
Ex
it the Tool Mode
1. Select the Clos
e button to exit any Tools Mode function without saving.
2. Select Clos
e to return to the Basic Copy tab.
Changing the Password
1. Select Change Too
ls Access Number button on the Tools screen.
2. Key-in a New Number i
n the New Number field.
3. Key-in the same number in Con
firm New Number in the Confirm New Number field.
4. Press the Enter butt
on.
5. Select the Clos
e button to return to System Administration Item.
GP 8 IDFE Power OFF/Power ON (PO/PO) Procedure
Description
This procedure is used when a full PO/PO is required for the Integrated Digital Front End
(IDFE).
Procedure
CAUTION
If any of the following steps are not correctly followed, the IDF
E will not shut down properly,
and the PO/PO process must be repeated.
NOTE: The IDFE will take approximately three to five minutes to load its software after per-
forming the following steps:
Perform the following:
1. Switch OFF the Main Switch for the Printer.
CAUTION
When power to the IOT is switched-off, the IDFE Hard Disk Drive goes into a software shut-
down. Damage to the Hard Disk Drive could occur if the IDFE is not allowed to complete the
software shut
down process.
2. Wait for 30 seconds.
3. Switch ON the Main Switch for the Printer.
NOTE: The configuration report may take 2 or 3 minutes to print.
To Next Page
Loading...
Need help?
General
