Xerox DocuColor 12/DCCS50

1/05
2-61
DocuColor 12/DCCS50
6-500 Lamp Not Ready RAP, 6-615 b* Failure RAP
Status Indicator RAPs
Reissue
6-500 Lamp Not Ready RAP
The Control Logic has detected that the Exposure Lamp Light did not reach the specified value
at Start.
Initial Actions
• Refer to BSD 6.1 and BSD 6.7 in the following procedure:
Procedure
PO/PO the machine. If the fault continues go to the 6-371 Exposure Lamp Fail RAP.
6-615 b* Failure RAP
The Control Logic has detected that the measured b* is out of the specific range.
Initial Actions
• Refer to BSD 6.2 and BSD 6.7 in the following procedure:
• Ensure that the PRE IPS PWB, CCD PWB, MEM SYS PWB and the POST IPS PWB and
the
ir connectors are seated properly.
• Check that the Option Memory PWBs are fully seated on the MEM SYS PWB.
Procedure
PO/PO the machine. If the fault continues go to Flag 1 on BSD 6.2 and check the wires for an
open or short circuit. If the fault continues, replace the following:
• CCD PWB (PL 3.
2).
• Pre IPS PWB (PL 3.5).
• MEM SYS PWB (PL 3.
5).
• POST IPS PWB (PL 3.
5).