1/05
4-3
DocuColor 12/DCCS50
REP 1.3.1
Repairs and Adjustments
Reissue
REP 1.3.1 Belt (Developer Drive)
Parts List on PL 1.3
Removal
WARNING
Turn power off and disconnect the power plug.
1. Remove the IOT Rear Cover (PL 1
1.3).
2. Remove the Toner Waste Bottle.
3. Open the IOT Control PWB Chassis (REP 9.2.
1).
4. Remove the flywheel and flange (Figure 1).
1.
Remove the screws (2).
2. Remove the Flywheel.
3. Loosen the screws (2).
4. Remove the flange.
Figure 1 Removing the Flywheel
5. Remove the Waste Toner Auger (REP 5.
5.1).
6. Remove the Main Motor (Figu
re 2).
1. Disconnect the connectors (2).
2. Remove the screws (4).
3. Remove the main motor.
Figure 2 Removing the Main Motor
7. Remove the Main Motor Bracket (Figu
re 3).
1. Remove the screws (7).
2. Remove the bracket.
To Next Page
Loading...
Need help?
General
