1/05
8d-98
DocuColor 12/DCCS50
REP 15.2.21, REP 15.2.22
Reissue
Finisher/Sorter
8. Slide the rear plastic bearing onto the rear end of Shaft 2, and use the screw (1) to secure
the bearing to the Finisher frame.
9. Slide the Eject Gear onto the rear end of Shaft 2, and
use an E-ring to secure the Gear to
the Shaft.
10. Slide the Offset Lever over the rear end of Shaft 2, and use an E-ring to secure the Offset
Lever.
11
. Reinstall the Eject Paddle Motor.
12. Reinstall the Eject Bracket Assembly.
13. Reinstall the Stacker Offset Home Sensor.
14. Reinstall the Eject Clamp Sensor.
15. Reinstall the Eject Roll Chute, and use the screws (4) to secure the Chute.
16. Reinstall the Harness Cover.
17. Reinstall the Compiler Cover Assembly.
18. Reinstall the Rear Lower Cover.
19. Reconnect the Finisher to the Printer.
REP 15.2.22 Compiler Cover Assembly
Parts List on PL 18.15
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Cover Assembly (REP 15.3.
3).
3. Remove the Rear Lower Cover (REP 1
5.3.15).
4. Remove the Stacker Tray Assembly (REP 15.2.
2).
5. Remove the Eject Cover (PL 18.15 item
10).
6. Remove the Compiler Cover Assembly (Figure 1).
1
. Remove the E-ring securing the Offset Lever to the rear of the Eject Pinch Roll Shaft.
Slid
e the Offset lever off the Eject Pinch Roll Shaft (rotate the Offset Cam if neces-
sary).
2. Remove the screw securing the Lever to the Eject Pinch Roll Shaft. Remove the
Lever
.
3. Rem
ove the screw (1) securing the rear Pinch Roll Bearing to the finisher frame, and
slide the Bearing t
o the rear.
4. Remove the screw securing the front Pinch Roll Bearing to the Finisher frame, and
slide the Bearing t
o the front.
5. Lift the Compiler Cover Assembly and the Pinch Roll Assembly and remove the
Compi
ler Cover Assembly from the finisher frame.
manuals4you.commanuals4you.com