EasyManuals Logo

Xerox DocuColor 12/DCCS50 User Manual

Xerox DocuColor 12/DCCS50
1617 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1248 background imageLoading...
Page #1248 background image
1/05
8d-106
DocuColor 12/DCCS50
REP 15.2.29, REP 15.2.30
Reissue
Finisher/Sorter
REP 15.2.29 Unload While Run Switch
Parts List on PL 18.15
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Cover Assembly (REP 15.3.
3).
3. Remove the Unload While Run Switch (Figu
re 1).
1. Remove the screw (1) securing the Switch Bracket to the Finisher frame, and
remove t
he Bracket.
2. Disconnect P/J10
75 from the Switch.
3. Remove the screw (1) securing the Switch to the Bracket, and remove the Switch.
Figure 1 Remove the Unload While Run Switch
Replacement
1. Reinstall the Unload While Run Switch onto the Switch Bracket.
2. With the screw (1) secure the Switch to the Bracket.
3. Reconnect P/J
1075 to the Switch.
4. Reinstall the Bracket to the Finisher frame, and use the screw (1) to secure it to the frame.
5. Reinstall the Stapler Cover Assembly.
REP 15.2.30 Compiler Entrance Sensor
Parts List on PL 18.14
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Cover Assembly (REP 15.3.
3).
3. Remove the Mailbox Door Assembly (REP 15.3.
5).
4. Remove the Compiler Entrance Sensor (Figure
1).
1. Disconnect the Compiler Entrance Sensor Connector P/J
1052.
2. Remove the screws (2) securing the Compiler Entrance Sensor Bracket.
3. Pull the Sensor Bracket up and remove the Compiler Enter Sensor.
Figure 1 Remove the Compiler Entrance Sensor
Replacement
1. Install the Compiler Entrance Sensor bracket into place.
2. Route the Compiler Entrance Sensor harness through the opening in the frame and con-
nect P/J1052 connect
or.
3. Install the screws (2) and secure the Compiler Entrance Sensor Bracket.
4. Install the Stapler Cover Assembly.
manuals4you.commanuals4you.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox DocuColor 12/DCCS50 and is the answer not in the manual?

Xerox DocuColor 12/DCCS50 Specifications

General IconGeneral
BrandXerox
ModelDocuColor 12/DCCS50
CategoryAll in One Printer
LanguageEnglish

Related product manuals