1/05
8d-116
DocuColor 12/DCCS50
REP 15.3.11, REP 15.3.12
Reissue
Finisher/Sorter
REP 15.3.11 Top Cover
Parts List on PL 18.2
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Rear Upper Cover (REP 15.3.
7).
3. Remove the Top Cover (Figu
re 1).
1. Open the Mailbox Door.
2. Loosen the one screw at the front of the cover.
3. Loosen the screw at the rear and the screw at the top inside.
4. Lift to remove the Top Cover.
Replacement
1. Replace the Top Cover in the reverse order of removal.
Figure 1 Remove the Top Cover
REP 15.3.12 Decurler Top Cover
Parts List on PL 18.5
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Roll the Finisher away from the printer
until the Finisher stops.
3. Remove the Decurler Top Cover (Figure 1
).
1. Remove the two screws on the left side of the cover.
2. Remove the one screw on the rear side of the cover.
3. Remove the Decurler Top Cover.
Replacement
1. Replace the Decurler Top Cover in the reverse order of removal.
Figure 1 Remove the Decurler Top Cover
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
