1/05
8d-74
DocuColor 12/DCCS50
REP 15.1.16, REP 15.1.17
Reissue
Finisher/Sorter
2. Route the Finisher Drive Belt onto the gears per the illustration (Figure 2).
Figure 2 Install the Finisher Drive Belt
3. Reinstall the belt idler bracket.
4. Reinstall the E-clip and the gear.
5. Reinstall the bracket with the motor.
NOTE: In the following step, ensure that the wires are secured away from belts, pulleys,
and
all moving component
s.
6. Reinstall the wire harnesses into the harness holders and reconnect the connector P/
J1084.
REP 15.1.17 Single Catch Tray (SCT) Assembly
Parts List on PL 18.3
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the Machine Power Cord.
1. Remove the Rear Upper Cover (REP 1
5.3.7).
2. Remove the Single Catch Tray (SCT) Assembly (Figur
e 1).
1. Remove the SCT Exit Cover.
2. Remove one screw from the bottom of the tray.
3. Lift up the tray, tilt out, and move the tray slightly away from the Finisher.
4. Disconnect the sensor connector.
5. Disengage the wire harness from the harness
holders on
the tray and remove the
tray.
Figure 1 Remove the Single Catch Tray (SCT) Assembly
Replacement
Reinstall the Single Catch Tray (SCT) Assembly in the reverse order of disassembly.
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
