Xerox DocuColor 12/DCCS50 User Manual

1/05
8d-7
DocuColor 12/DCCS50
11-108 SCT Exit Sensor Off Jam RAP
Finisher/Sorter
Reissue
11-108 SCT Exit Sensor Off Jam RAP
The SCT Exit Sensor did not deactuate within the specified time after the SCT Exit Sensor
actuated.
Initial Actions
Refer to BSD12.5 and BSD12.7 for the following procedure.
Check for the following:
• Obstructions in the Mailbox paper path
• Bent or out of position paper chutes/guides in the Mailbox paper path
• Ensure that there is sufficient nip force a
t t
he Mailbox Transport Roll and the SCT Exit
Roll.
• Ensure that connectors P/J1
040 on the Mailbox PWB and P/J1076 on the SCT Exit Sen-
sor are seated correctly and there are no obvious cr
imped or broken wires.
Procedure
The trail edge of the paper is past the SCT Exit Sensor
YN
Enter dC330 012-005 Mailbox Drive Motor. Press Sta
rt. T
he Mailbox Transport Roll is
rotating.
YN
The Mailbox drive Belt is moving.
YN
The Mailbox Drive Motor is rotating
YN
+24 VDC is measured between P/
J1021-1 and
P/J1021-2 of the Mail-
box Drive Motor
YN
Go to F
lag 3 on BSD
12.5. Check the wires for an open circuit. If the
wires are good, replace the Mailbox PWB (PL 18.11).
Press Stop. +5
VDC is measured between P/J1021-3 and GND.
YN
Go to Fl
ag 1 and Fl
ag 2 on BSD12.5. Check the wires for an open
circuit. If the wires are good, replace the Mailbox PWB (PL 18.11).
Press Start. Less
than +1 VDC is measured between P/J1021-3 and
GND.
YN
Replace the Mailbox PWB (P
L 1
8.11)
Replace the Mailbox Drive Motor (PL 18.10).
Ens
ure that the Mailbox Drive Motor Pulley is fastened to the motor shaft.
• Check the Drive Belt Tension Roll for proper tension.
• Check the Drive Belt for Damage
• Check that the gear pulleys are properly f
as
tened to the drive rolls
Check the following parts for wear, glazing, or slipping.
• Mailbox Entrance Roll (PL 18.10)
•
Pinch Rollers (PL 18.12
)
• SCT Exit Roll (PL 18.10)
• D
rive Belt (PL 1
8.10)
Check the Drive Belt Tension Roll for proper tension.
Check the SCT Exit Sensor Actuator for binding as it moves in and out of the sensor. The
act
uator is binding.
YN
Check for obvious damage, missing and/or broken D
ri
ve Motor gear assemblies and drive
belts that would cause the copy to be slow to actuate the SCT Exit Sensor.
Replace the SCT Exit Sensor (PL 18.13
).
A
A
B
B

Xerox DocuColor 12/DCCS50 Specifications

General

Brand	Xerox
Model	DocuColor 12/DCCS50
Category	All in One Printer
Language	English