EasyManuals Logo
Home>Xerox>All in One Printer>DocuColor 12/DCCS50

Xerox DocuColor 12/DCCS50 User Manual

Xerox DocuColor 12/DCCS50
1617 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #261 background imageLoading...
Page #261 background image
1/05
2-225
DocuColor 12/DCCS50
15-380/15-381 / 15-382 / 15-383 / 15-384 / 15-385
Status Indicator RAPs
Reissue
PO/PO the machine. If the Fault continues, ensure that the P/J514 on the Pre IPS PWB and
MEM SYS PWB, P/J560 on the MEM SYS PWB and POST IPS PWB are fully seated. If the
Fault continues, replace the following:
• MEM SYS PWB (PL
3.
5)
• POST IPS PWB (PL 3.
5)
• PRE IPS PWB (PL 3.5)
15-386 / 15-387 / 15-388 / 15-389 / 15-390 / 15-391 CCD AOC
Fail RAP
The Automatic Offset Control (AOC) for a specific signal from the CCD PWB could not set the
value within range.
15-386: CCD Channel 1 RED (odd) AOC Fail
15-387: CCD Channel 2 RED (even) AOC Fail
15-388: CCD Channel 3 GREEN (odd) AOC Fail
15-389: CCD Channel 4 GREEN (even) AOC Fail
15-390: CCD Channel 5 BLUE (odd) AOC Fail
15-391: CCD Channel 6 BLUE (even) AOC Fail
Initial Actions
Refer to BSD 6.2 and BSD 6.7 in the following procedure.
Procedure
Switch off the power. Go to Flag 1 on BSD 6.2 and check the Flat Cable for damage. Reseat
the Flat Cable connector P/J500 and P/J510.
If the problem continues, replace t
he following
• CCD PWB (PL 3.
2)
• Pre-IPS PWB (PL 3.
5)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox DocuColor 12/DCCS50 and is the answer not in the manual?

Xerox DocuColor 12/DCCS50 Specifications

General IconGeneral
BrandXerox
ModelDocuColor 12/DCCS50
CategoryAll in One Printer
LanguageEnglish

Related product manuals