1/05
8d-75
DocuColor 12/DCCS50
REP 15.1.18, REP 15.1.19
Finisher/Sorter
Reissue
REP 15.1.18 SCT Static Eliminator
Parts List on PL 18.13
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the Machine Power Cord.
1. Remove the Rear Upper Cover (REP 15.3.
7).
2. Remove the SCT Static Eliminator (Figu
re 1).
1. Remove the SCT Exit Cover.
2. Remove the Static Eliminator.
Figure 1 Remove the SCT Static Eliminator
Replacement
Align the Static Eliminator strip with the top of the SCT Exit Upper Chute, from which you
removed the old Static Eliminator, and stick the strip in place.
REP 15.1.19 SCT Exit Sensor
Parts List on PL 18.13
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the Machine Power Cord.
1. Remove the Rear Upper Cover (REP 1
5.3.7).
2. Remove the SCT Exit Sensor (Figur
e 1).
1. Remove the SCT Cover.
2. Disconnect the Sensor Connector.
3. Remove the SCT Exit Sensor.
Figure 1 Remove the SCT Exit Sensor
Replacement
Reinstall the SCT Exit Sensor in the reverse order of disassembly.
To Next Page
Loading...
Need help?
General
