1/05
3-33
DocuColor 12/DCCS50
IQ 32 ROS Borders RAP, IQ 33 Solid Area Repro-
Image Quality
Reissue
IQ 32 ROS Borders RAP
Intentional border deletions that exceed specifications (refer to ROS Borders for details).
Procedure
Perform the ADJ 9.1.10 Side/Lead Edge Registration (dC129: System Registration).
IQ 33 Solid Area Reproduction RAP
Initial Actions
Load some new, dry 24 lb 11X17/A3 Xerox COLOR Xpressions (NASG), or 90 GSM Colortech
+ (ESG) into the paper tray. Make full color copies and check the Solid Area Reproduction.
NOTE: After replacing developer material, go to IQ47 ATC Sensor RAP, Appendix 1. AT
C set-
up procedure.
Procedure
Perform the following:
• Replace the developer if the developer is near or over HF
SI threshold.
• Replace the IBT Belt if the IBT Belt is over HFSI threshold.
•Perform ADJ 9.
1.1 Max Setup.
• Check for Mottle/BCO IQ 22
Mottle RAP.
• Check the 1st BTR HVPS IQ 4
1 1st BTR HVPS RAP.
• Check the 2nd BRT HVPS IQ 40
2nd BTR HVPS RAP
To Next Page
Loading...
Need help?
General
