1/05
8d-107
DocuColor 12/DCCS50
REP 15.2.31
Finisher/Sorter
Reissue
REP 15.2.31 Eject Paddle Home Sensor
Parts List on PL 18.19
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Roll the Finisher away from the printer until it stops.
3. Remove the Rear Lower Cover (REP 15.3.
15).
4. Remove the Eject Clamp Sensor (REP 15.2.
17).
5. Remove the Stacker Offset Home Sensor (REP 1
5.2.18).
6. Remove the Eject Bracket Assembly (REP 15.
2.19).
7. Remove the Eject Paddle Motor (REP 15.2.
20).
NOTE: Do not remove the Motor from the Bracket.
8. Remove the Eject Paddle Home Sensor (Figu
re 1).
1. Press in and release the Sensor latches that secure the Sensor to the Bracket, and
remove t
he Sensor.
Figure 1 Remove the Eject Paddle Home Sensor
Replacement
1. Position the Eject Paddle Home Sensor into the cutout in the Motor Bracket.
2. Reinstall the Eject Paddle Motor.
3. Reinstall the Eject Bracket Assembly.
4. Reinstall the Stacker Offset Home Sensor.
5. Reinstall the Eject Clamp Sensor.
6. Reinstall the Upper Rear Cover.
7. Reconnect the Finisher to the Printer.
To Next Page
Loading...
Need help?
General
