Xerox DocuColor 12/DCCS50 User Manual

1/05
4-127
DocuColor 12/DCCS50
REP 8.3.5
Repairs and Adjustments
Reissue
REP 8.3.5 Heat Roll Stripper Finger
Parts List on PL 8.3
Removal
WARNING
Turn power off and disconnect the power plug.
CAUTION
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
1. Open the Front Door.
2. Remove the Fuser Unit (REP
8.1.
1).
3. Remove the Heat Roll Stripper Finger Assembly (Figure 1
).
NOTE: Do not damage the Stripper finger tips.
1. Raise the Exit Chute.
2. Loosen the screw.
3. Remove the screw.
4. Remove the Heat Roll Stripper Finger Assembly.
Figure 1 Remove the Heat Roll Stripper Finger Assembly
4. Remove the Heat Roll Stripper Finger (Fi
gu
re 2).
1. Remove the spring tip from the groove.
2. Remove the stud.
3. Remove the spring.
4. Remove the Heat Roll Stripper Finger.
Figure 2 Remove the Heat Roll Stripper Finger
Installation
1. Install the Heat Roll Stripper Finger (Figure 3).

Xerox DocuColor 12/DCCS50 Specifications

General

Brand	Xerox
Model	DocuColor 12/DCCS50
Category	All in One Printer
Language	English