1/05
5-1
DocuColor 12/DCCS50
Parts Lists
Reissue
5 Parts List
Overview
Introduction ..................................................................................................................... 5-3
Subsystem Information ................................................................................................... 5-4
Symbology ...................................................................................................................... 5-5
Parts Lists
Drive
PL 1.1 Drum/IBT Drive .................................................................................................... 5-7
PL 1.2 Main Motor, Drum Brush Drive ............................................................................ 5-8
PL 1.3 Deve./BPD Drive, IBT Cleaner Retract................................................................ 5-9
PL 1.4 2nd BTR/Oil Roll/Auger Drive .............................................................................. 5-10
PL 1.5 Main Motor 2, Tray 5/Regi./Tray 1 Take Away Drive........................................... 5-11
PL 1.6 Fuser/Exit Drive ................................................................................................... 5-12
Paper Transport
PL 2.1 Tray 1/2/3/4, Tray Sensor, Label ......................................................................... 5-13
PL 2.2 Tray 1 Component ............................................................................................... 5-14
PL 2.3 Tray 2/3/4 Component ......................................................................................... 5-15
PL 2.4 Tray 1-4 Feeder ................................................................................................... 5-16
PL 2.5 Feeder Component (Part 1 of 2).......................................................................... 5-17
PL 2.6 Feeder Component (Part 2 of 2).......................................................................... 5-18
PL 2.7A Tray 2-4 Take Away Drive (Part 1 of 2)............................................................. 5-19
PL 2.7B Tray 2-4 Take Away Drive (Part 2 of 2)............................................................. 5-20
PL 2.8 Left Lower Cover ................................................................................................. 5-21
PL 2.9 Tray 5 Unit, Tray 5 Feed Clutch/Roll ................................................................... 5-22
PL 2.10 Tray 5 Upper (Part 1 of 2).................................................................................. 5-23
PL 2.11 Tray 5 Upper (Part 2 of 2).................................................................................. 5-24
PL 2.12 Tray 5 Base ....................................................................................................... 5-25
PL 2.13 Tray 5 Tray ........................................................................................................ 5-26
PL 2.14 Regi. Unit, DTS HVPS ....................................................................................... 5-27
PL 2.15 Regi.-Regi.......................................................................................................... 5-28
PL 2.16 Regi.-Pre Regi. .................................................................................................. 5-29
PL 2.17 Vacuum Transport ............................................................................................. 5-30
PL 2.18 Drawer Accessory, Duplex Baffle ...................................................................... 5-31
PL 2.19 Drawer Frame, Duplex Out Motor/Roll, Duplex Chute....................................... 5-32
PL 2.20 Duplex In/Aligner Baffle Component.................................................................. 5-33
PL 2.21 Duplex In/Aligner Chute Component ................................................................. 5-34
PL 2.22 Drawer Frame Component ................................................................................ 5-35
PL 2.23 Inverter Unit ....................................................................................................... 5-36
PL 2.24 Inverter 1 Component ........................................................................................ 5-37
PL 2.25 Inverter 2 Component (Part 1 of 2) .................................................................... 5-38
PL 2.26 Inverter 2 Component (Part 2 of 2) .................................................................... 5-39
IIT
PL 3.1 Platen Glass: ITT ................................................................................................. 5-40
PL 3.2 CCD PWB, Sensor .............................................................................................. 5-41
PL 3.3 Carriage Cable/Motor .......................................................................................... 5-42
PL 3.4 Full/Half Rate Carriage ........................................................................................ 5-43
PL 3.5 IPS ......................................................................................................................
. 5-44
ROS
PL 4.1 ROS ..................................................................................................................... 5-45
Xerographics
PL 5.1 ESV Sensor, Erase Lamp.................................................................................... 5-46
PL 5.2 CC/PCC Connector, Waste Toner Bottle (IOT Rear)........................................... 5-47
PL 5.3 Drum Component................................................................................................. 5-48
PL 5.4 Charge/Pre Clean Corotron ................................................................................. 5-49
PL 5.5 Waste Toner Auger.............................................................................................. 5-50
Development
PL 6.1 Development Components .................................................................................. 5-51
PL 6.2 Toner Cartridge Unit ............................................................................................ 5-52
PL 6.3 Toner Cartridge Component (Part 1 of 2) ............................................................ 5-53
PL 6.4 Toner Cartridge Component (Part 2 of 2) ............................................................ 5-54
PL 6.5 Rotary Dispenser ................................................................................................. 5-55
PL 6.6 Deve. Housing ..................................................................................................... 5-56
PL 6.7 Rotary Frame/Auger ............................................................................................ 5-57
IBT
PL 7.1 IBT System Component....................................................................................... 5-58
PL 7.2 Rail Front Plate .................................................................................................... 5-59
PL 7.3 Left/Right Rail ...................................................................................................... 5-60
PL 7.5 IBT-Belt, Sensor, Steering Roll............................................................................ 5-61
PL 7.6 IBT Component (Part 1 of 2)................................................................................ 5-62
PL 7.7 IBT Component (Part 2 of 2)................................................................................ 5-63
PL 7.8 IBT Cleaner.......................................................................................................... 5-64
PL 7.9 2nd BTR............................................................................................................... 5-65
PL 7.10 2nd BTR Component ......................................................................................... 5-66
Fusing
PL 8.1 Fuser Unit, Front Cover ....................................................................................... 5-67
PL 8.2 Fuser Sub Assembly............................................................................................ 5-68
PL 8.3 Heat/Pressure Roll............................................................................................... 5-69
PL 8.4 Heat Roll Sensor, External Heat Roll Retract/Web Motor.................................... 5-70
PL 8.5 Web Shutter, Cleaning Roll (Heat Roll) ............................................................... 5-71
PL 8.6 Pressure Roll Sensor, Pressure Roll Nip............................................................. 5-72
PL 8.7 Oil Pump/Tank ..................................................................................................... 5-73
PL 8.8 External Heat Roll................................................................................................ 5-74
PL 8.9 Pick Up/Donor Roll............................................................................................... 5-75
PL 8.10 Exit Chute .......................................................................................................... 5-76
Electrical
PL 9.1 Front, Right .......................................................................................................... 5-77
PL 9.2 IOT Top/Rear....................................................................................................... 5-78
PL 9.3 Tray Module, Rear ............................................................................................... 5-79