Xerox DocuColor 12/DCCS50

1/05
4-119
DocuColor 12/DCCS50
REP 8.3.1
Repairs and Adjustments
Reissue
Figure 5 Remove the Heat Roll
10. Wipe off and then inspect the Heat Roll Thermistors (2) for wear or damage and replace
them as
needed.
Installation
NOTE: Ensure that the bearings are installed with the flanges toward the center of the roll so
that they fit inside the Fuser Frame (Figure 6).
Figure 6 Install the Heat Roll
NOTE: When installing the Heat Roll, press the stoppers down and lock the Heat Roll (Figure
7).
1.
Press down the stoppers (2).
2. Tighten the screws (2).