1/05
8d-122
DocuColor 12/DCCS50
REP 15.3.18
Reissue
Finisher/Sorter
2. Remove the ten screws securing the Upper Rail to the Lower Rail, and remove the
Upper Rail.
3. Remove the screw securing the Belt Clamp to the Slider Bracket.
4. Disengage the Belt from the Lower Rail.
5. Remove the Belt from the Belt Clamp.
Figure 2 Remove the Stapler Rail Belt
Replacement
1. Ensure that the belt is positioned as shown in the illustration and reinstall the Belt Clamp
onto the Belt.
2. Reinstall the Belt on the Lower Rail.
3. Reinstall the Belt Clamp onto the Slider Bracket, and use one screw to secure the Clamp.
Ensure t
hat the tension idler engages the belt.
4. Push out on the Tension Bracket so that the springs are stretched, and reinstall the Upper
Rail onto the L
ower Rail.
5. Reach under the Lower Rail and position the Belt so the back (non-ribbed side) of the Belt
rides against t
he Tension Roll.
6. Release the Tension Bracket.
7. Use the remaining screws to secure the Upper Rail to the Lower Rail. Ensure that the belt
moves fr
eely without binding.
8. Reinstall the Tension Cover over the Tension Bracket, and use two screws to secure the
Cover
to the Upper Rail.
9. Rotate the Drive Pulley to make sure that the Belt tracks correctly and that the Slider
Bracket m
oves smoothly along the Rail.
10. Reinstall the Stapler Rail into the Finisher frame. Use four screws to secure the Rail to
the
frame.
11. Reconnect the P/J connectors to the sensors.
12. Route the wire harness through the harness clips that
are located on the Stapler Rail.
13. Rotate the Stapler Transport Motor Drive Belt as you slip
the Belt onto the Drive Pulley.
14. Reinstall the Stapler Assembly.
15. Reinstall the Rear Lower Cover.
16. Reinstall the Stapler Cover.
17. Reconnect the Finisher to the Printer.
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
