1/05
4-206
DocuColor 12/DCCS50
ADJ 9.1.10
Reissue
Repairs and Adjustments
3. Select Start.
NOTE: If the Lead Edge Registration cannot be brought within specification, the NVM value for
the st
arting point may be out of range. Reset NVM location 761-048 to the default value of
1000 and perform the adjustment again.
4. Repeat the check/adjustment until the specifications are met.
5. Select Save [LR
] to save the new NVM settings.
Duplex Side Edge:
1. Use the Up and Down Arrow buttons to move the image toward
or away from the outboard
edge of the paper. Each click on the button moves the image 0.0423 mm. The cumulative
amount of shift is indicated in the Side Reg. box.
2. After adjusting the registration, click S
et
Adjust Value.
3. Select Start.
NOT
E: If the Side Edge Registration cannot be brought within specification, the NVM value for
the st
arting point may be out of range. Reset NVM location 720-008 to the default value of
7406 and perform the adjustment again.
4. Repeat the check/adjustment until the specifications are met.
5. Select Save [SR] to sa
ve the new NVM settings.
manuals4you.commanuals4you.com
To Next Page
Loading...
Need help?
General
