Xerox DocuColor 12/DCCS50 User Manual

1/05
8d-56
DocuColor 12/DCCS50
12-570, 12-571
Reissue
Finisher/Sorter
YN
Go to Flag 10, Fl
ag 11 and Flag 14 on BSD 12.15. Check for an open circuit. If the wires
are good, replace the Stacker Full (Mixed Size) Sensor (PL 18.27).
Press the C butto
n. Enter dC330 012-212 Stacker Full (Mixed Sets) Sensor. Press Start. The
display is Low.
YN
Go to F
lag 12, F
lag 13 and Flag 14 on BSD 12.15. Check for an open circuit. If the wires
are good, replace the Stacker Full Sensor (PL 18.27).
The problem appears to be intermittent. Go to Flag
8, Flag 9,Flag 10, Flag 11, Flag 12, Flag 13,
and Flag 14 on BSD 12.15. Check the circuits of the Stacker Sensor s for a loose connection or
an intermittent short circuit to GND
12-571 RAP
Control Logic detected the signal Stacker Full (Mixed Set) (H) while mixed-size sets were
present in the Stacker Tray.
Initial Actions
Refer to BSD 12.15 for this procedure.
Ensure that the Stacker Tray is empty. If the fault is d
eclared with an empty Stacker Tray, pro-
ceed with this RAP.
Procedure
Enter dC330 012-253 Stacker Paper Sensor. Press Start. The display is Low.
YN
Go to F
lag 8 and Flag 9 on BSD 12.15. Check for an open circuit. If the wires are good,
replace t
he Stacker Paper Sensor (PL 18.27).
Press the C button.
Enter dC330 012-210 Stacker Full Sensor. Press Start. The display is
Low.
YN
Go to F
lag 10, Fla
g 11 and Flag 14 on BSD 12.15. Check for an open circuit. If the wires
are good, replace the Stacker Full (Mixed Size) Sensor (PL 18.27).
The problem appears to be intermittent. Go to Flag 8, F
lag 9, Flag 10, Flag 11, and Flag 14 on
BSD 12.15. Check the circuits of the Stacker Sensors for a loose connection or an intermittent
short circuit to GND
manuals4you.commanuals4you.com

Xerox DocuColor 12/DCCS50 Specifications

General

Brand	Xerox
Model	DocuColor 12/DCCS50
Category	All in One Printer
Language	English