Xerox DocuColor 12/DCCS50 User Manual

1/05
6-98
DocuColor 12/DCCS50
dC301 NVM Initialization
Reissue
General Procedures
13. Go to dC371 Configuration Page. Verify the machine configuration. Correct any errors
before continuing.
14. Exit the Diagnostic Mode. To exit Diagnostic Mode, refer to dC188 How t
o Exit from Ser-
vice Mode.
15. Reconnect any Foreign Int
erface devices.
16. Run several copies/prints to confirm normal machine behavior.
17. Re-enter the Diagnostic Mode.
18. Set NVM location 715-001 to 0.
Set NVM location 720-368 to 0
19. Perform M
ax Se
tup (ADJ 9.1.1).
20. Exit the Diagnostic Mode.
Table 2 v11.50.3 software
Location Value
700-191 1
700-193 0
700-099 1
710-062 0
710-063 0
720-794 62
730-027 260 (C/P only)
752-002 0 = no Foreign Interface
NOTE: When F/I is plugged in at
power
-up, s
oftware will automati-
cally enable F/I (value=1).
752-004 0
752-012 0 = No Edit Pad
1 = Edit Pad Installed
752-017 1
759-004 0 = DC12 with DFE
1 = DCCS 50
Use default for DC12 w/o DFE
759-047 0
759-051 0
759-041 1
759-042 1
761-424 0
990-302 1
990-303 0
Table 3 v7.06.3 software
Location Value
710-062 0
710-063 0
752-002 0 = no Foreign Interface
NOTE: When F/I is plugged in at
power
-up, s
oftware will automati-
cally enable F/I (value=1).
752-012 0 = No Edit Pad
1 = Edit Pad Installed
759-004 0 = DC12 with DFE
1 = DCCS 50
Use default for DC12 w/o DFE
Table 3 v7.06.3 software
Locati
on Value
manuals4you.commanuals4you.com

Xerox DocuColor 12/DCCS50 Specifications

General

Brand	Xerox
Model	DocuColor 12/DCCS50
Category	All in One Printer
Language	English