CHYRON Corporation
Message Compose Basics 6-14 Revision D
To exit Font Load Utility when the font load procedure is
complete:
• Press
Q or CNTL.
8VLQJ)RQW.H\V
To use a font that has been loaded into a Font Key:
[ ] 1. While in the Message Compose main menu,
press the
Font Key or ALT Font Key which
corresponds to the font that you would like to
type.
OR...
Click on the appropriate Fonts Loaded Box.
[ ] 2. Start typing!
&17/5($'5($'1(;7/RDG
CNTL READ and CNTL READ NEXT enable you to load
fonts automatically when you recall recorded messages.
These fonts must be in the font directory that is currently
open.
For example, if you have a message stored at address
0000, pressing CNTL READ loads the font(s) you used to
create that message, based on the 4-digit ID number that
is stored in the current directory. These fonts are loaded
into the same Font Keys that were assigned when you
recorded the message, as long as they are stored in the
font directory that is currently open. Be aware that if you
are not currently in the font directory in which you stored
the fonts that you used to create the message,
CNTL
READ
may load fonts with the same ID numbers, but that
may not be the fonts that you expect.
By entering a message ID number, then pressing
CNTL
READ NEXT, the system loads the message and its fonts
into the Read Next Buffer. The contents of this buffer
To Next Page
Loading...