Chyron infinit! series - 17.13 Reading Multiple Effects Messages; 17.14 Exiting Multiple Effects Main Menu

CHYRON Corporation
Multiple Effects 17-46 Revision D
 5HDGLQJ0XOWLSOH(IIHFWV0HVVDJHV
To read a Multiple Effects message:
[ ] 1. Press
CLR, then enter the ID number of the
Multiple Effects message using the Address
Keypad. This can be done either from the
Message Compose main menu or from within
the Multiple Effects main menu.
[ ] 2. Press
READ.
[ ] 3. If not in the Multiple Effects main menu, press
CNTL E or select Multi FX.
[ ] 4. Execute as described in §17.10.
 ([LWLQJ0XOWLSOH(IIHFWV0DLQ0HQX
To exit the Multiple Effects main menu and save settings:
• Press
CNTL Q, select Quit or click the right mouse
button.
Settings are saved until exiting Message Compose, or
rebooting or turning off the system.
To exit the Multiple Effects main menu without saving
new settings:
• Press
ESC.
On exiting the Multiple Effects main menu, the settings
revert to those that were set when the menu was entered.