Chyron infinit! series - 13.15.2.3 Function Icons; 13.15.3 Options

iNFiNiT! Family Operation Manual
Revision D 13-53 Flash Font
 )XQFWLRQ,F RQV
 2SWL RQV
Bevel and Texture surface options are set in the Options
window (Figure 13-29). To display the Options window:
• Press
O or select Options.
Light
• Press L or select Light to toggle between the presets
for
LIGHT 1 (green pyramid) and LIGHT 2 (yellow
pyramid).
Conv
• After setting all parameters, press CNVRT (FLASH)
or select
Conv (FLASH).
Generating xxx 3D surfaces. ESC to abort, then X
sections to process
appear on the Prompt Line while
the conversion is executing. The conversion is complete
when the Prompt Line clears.
• Press
ESC to abort a conversion.
Fast
Conv
This function Performs a stair-stepped conversion, where
not as many 3D surfaces are created, but a substantial
amount of time is saved in the conversion.
Use this as a
preview, then, if satisfied with the appearance, use
Conv to achieve a full resolution image.
Reset
• Press R or select Reset to restore all 3D Utility win-
dow settings except
Options to default settings.
Quit
This function exits the 3D Utility, and saves the current
settings, including both light presets.
• To exit and erase any changes in the window, press
ESC. A conversion can also be aborted at any time
by pressing
ESC.
Options
Options
(§13.15.3) opens the Options window (Figure
13-29), to allow you select
Bevel (§13.15.3.1) and Tex-
ture
(§13.15.3.2).