Chyron infinit! series - 18.7.3 Reading a Character Placement Table; 18.7.4 Exiting the Character Placement Window

CHYRON Corporation
Font Create Utility 18-34 Revision D
 5HDGLQJD&KDUDFWHU 
3ODFHPHQW7DEOH
To read a recorded character Placement Table:
[ ] 1. While in the Font Create main menu, press
CNTL P.
[ ] 2. Press
READ. The Character Set Identification
Window (Figure 18-17) appears.
[ ] 3. Press
CLR, then enter the three character name
of the table in the
Character Set ID: field.
[ ] 4. Press

. The Character Set Identification
window disappears, and the Character
Placement Table is displayed.
To read the default table:
• Follow the above procedure, entering
STD (Standard
Table) of
ITL (International Table) in the Character
Set ID:
field.
To exit the Character Set Identification window without
performing the read:
• Press
CNTL or ESC.
 ([LWLQJWKH&KDUDFWHU 
3ODFHPHQW:LQGRZ
To exit the Character Placement window and return to the
Font Create main menu:
• Press
CNTL or ESC.