CHYRON Corporation
Advanced Playback 9-38 Revision D
The commands are outlined in the following sections.
Enter all numeric data using the Address Keypad.
&UDZO&
Crawl specifies which message(s) to crawl. In a Crawl
command, a single message or a range of messages can
be specified. Additionally, the same message(s) can be
specified multiple times in the list.
[ ] 1. Press
CRAWL or C.
[ ] 2. Enter the ID number of the message to be
crawled, then press
.
[ ] 1. To specify a range of messages to be crawled:
[ ] 2. Enter the ID number of the first message to be
crawled,
then press
Í.
[ ] 3. Enter the ID number of the last message to be
crawled; then press
.
NOTE
The Crawl message and the text
messages specified in the Crawl
Control Buffer List MUST be stored in
the SAME Directory, i.e. the current
directory, or the Crawl Control Buffer
cannot access them! All messages
must use the same 16 fonts, loaded
into the same 16 positions. Messages
that do not are ignored, and not
crawled.
5RZV&
Rows specifies the number of rows to be crawled.
[ ] 1.
Press R.
To Next Page