Chyron infinit! series - 2.14.7 WiNFiNiT! Software Installation

CHYRON Corporation
Installation 2-66 Revision D
[ ] 12. Press X or select Execute. when COPY
COMPLETE is displayed, remove the disk.
[ ] 13. Press CNTL Q or select Quit to return to the Disk
Utilities main menu, then press MODE SLCT to
return to the Loader menu.
[ ] 14. Press SET-UP B or select Reboot to restart the
system. This step is mandatory!
The software is now fully installed. Store the disk in a cool, dry
place.
 :L1)L1L76RIWZDUH,QVWDOODWLRQ
The following instructions can also be found in Section 3 of the
WiNFiNiT! Option Handbook (Pub. No. 2A02024).
[ ] 1. Close any Windows 95 or Windows NT program(s)
that you are using.
[ ] 2. Insert WiNFiNiT! Install Disk 1 in the floppy disk
drive.
[ ] 3. Select
Run
from the Start menu, or
Install
from
the
Add/Remove Programs Properties
Install/Uninstall
menu.
[ ] 4. In the
Open:
or
Command line for installation
program:
field, enter
a:\Setup.exe
. If the disk
drive has a different label, change “
a
” to the proper
letter.
[ ] 5. Follow the directions that appear on the screen.
[ ] 6. When prompted, remove Disk 1 and insert Disk 2.
NOTE: If a previous version of WiNFiNiT! had
already been in the system, it is possible that certain
files may be still up to date. In this case, the system
will complete installation without requesting the
second disk.
The PC display a prompt when installation is complete. Unless
specified otherwise during installation, you can now open
WiNFiNiT! from within the Programs menu.