Chyron infinit! series - 9.4.2.6 Time (T); 9.4.2.7 GoTo (G)

CHYRON Corporation
Advanced Playback 9-42 Revision D
 7LPH7
Time sets a fixed duration for the Crawl. Used in place
of the
Speed command, Time computes the speed based
on the entered duration, and is calculated from the point
that the Crawl executes, to the point that the last charac-
ter clears the screen.
NOTE
Timed Crawl calculations include
Pause commands, but do not execute
Speed commands!
[ ] 1. Enter the following command before any
Crawl commands in the list: Press T.
[ ] 2. Enter the duration of the Crawl in minutes and
seconds, up to
99:99, then press

.
 *R7R*
GoTo jumps from a step in the Crawl Control Buffer List
to any other specified step in the list.
To enter a
GoTo command:
[ ] 1. Press
G.
[ ] 2. Enter a destination step number from
0 to 99,
then press

.
NOTE
If the destination step is earlier in the
list than the GoTo command, an
endless loop is created. To stop and
exit the Crawl while this endless loop
is being executed:
• Press ESC.