Chyron infinit! series - 17.8 Recall Pre (Recall Presets)

iNFiNiT! Family Operation Manual
Revision D 17-35 Multiple Effects
Position the mouse cursor on the Start Point of
the effect, then drag the Start Point to its new
position.
To change the End Point of an effect:
[ ] 1. Place the cursor on the Time Line you want to
change.
[ ] 2. Press
SHIFT ROW + Í or Î to move the End
Point to the right (to end later), or
SHIFT ROW
+
Ì or Ï to move the End Point to the left (to
end earlier).
OR...
Position the mouse cursor on the End Point of
the effect, then drag the End Point to its new
position.
To move the Start and End Points of an effect without
changing its length:
[ ] 1. Place the cursor on the Time Line you want to
change.
[ ] 2. Press
SHIFT PAGE + Í or Î to move the
effect to the right (to start and end later), or
SHIFT PAGE + Ì or Ï to move the effect to
the left (to start and end earlier).
OR...
Position the mouse cursor on the middle of the
effect Time Line, then drag the Time Line to its
new position.
 5HFDOO3UH5HFDOO3UHVHWV
Using the Recall Pre function, you can Recall Read
Effects and Mix Effects presets recorded to a message in
a directory. Remember that both the Read Effects and
Mix Effects presets that were recorded to that message
ID number are Recalled, for a total of
200 presets.