iNFiNiT! Family Operation Manual
Revision D 15-33 Advanced Read FX
2XWSXW3HUFHQWDJH/HYHOV
The Output Percentage level of the video signal of each
buffer is controlled by a Percent slider. Output Percent-
age level can be set from
0 to 100 inclusive.
•
0: Output Percentage level of the video signal is 0.
The image
cannot be seen.
•
100: Output Percentage level of the video signal is
100. Image appears completely opaque, and covers
any image that is behind it.
•
1 - 99: Image appears to be very transparent (1) to
almost completely opaque (
99). Other images set
behind these images can show through.
Cursor to the slider you want to adjust. There are three
ways to adjust a slider:
• Press
CLR; enter a value between 0 and 100, then
press
.
• Press
SHIFT CHAR + Ì or Í as many times as
necessary to reach the desired setting.
• Use the mouse to drag the Percent slider to the
desired Output Percentage level.
NOTE
When a Special Roll is executed in an
EEFB, the Background/Foreground
Output Percentage levels for that
buffer are overridden. The
Foreground output is automatically
set 100%; the Background output is
set to 0%.
To Next Page
Loading...