iNFiNiT! Family Operation Manual
Revision D 12-7 Function Keys
.H\VWURNH$EEUHYLDWLRQV
When entering commands into the Function Key list,
what appears in the list may not exactly match what is
printed on the keycap(s) of the keys used to enter the
command(s). Enter these commands when the cursor is
in the Keystroke column.
Table 12-1: Editing Commands
.H\VWURNH )XQFWLRQ
Ï or Î Scrolls to the next or previous page of the list. 38 steps are visible
at one time. Repeat keystroke as necessary.
INS ROW Inserts a blank step at the step number where you position the
cursor. All following keystrokes move down one step number.
Cursor
Í to move to the Keystroke column, then enter the new
command. If there are leftover blank steps, they are skipped dur-
ing execution. They can also be removed using the
DEL ROW
command described below.
DEL
ROW
Deletes a row at the step where the cursor is positioned. All suc-
cessive keystrokes move up one step number.
MOVE
Allows you to move an existing step to another location. Sur-
rounding steps move to accommodate the new position. Steps
are not overwritten. See §12.3.6 for more details.
HOME Repositions the cursor to Step 0.
Address
Keypad
Moves the cursor directly to a specified step number. For exam-
ple, press
CLR, then enter 99 on the Address Keypad to place
the cursor at Step #99, which now moves to the top of the list.
ERASE Clears out all entries from the list, and returns the cursor to Step 0.
• To undo an erase command, press
ESC, then press the
Function Key to re-enter the list.
ESC Exits from Function Key mode, without retaining any changes to
the list.
RCD Saves the current Function Key List to disk.
To Next Page