Chyron infinit! series - 10.3.2 Setting Character Edge Color; 10.3.3 Picking Up & Depositing Color; 10.3.4 Recalling Numeric Slider Values

CHYRON Corporation
Colors & Palettes 10-10 Revision D
 6HWWLQJ&KDUDFWHU(GJH&RORU
[ ] 1. Press E or select Set Edge.
[ ] 2. Follow the procedure described in §10.3.1,
Step 1, to set the edge color.
[ ] 3. Press the Color Key in which the new color is
to be stored.
It is not necessary to set an edge color for a Color Key.
If you change the face color of a Color Key, but do not
create a new edge color, the edge remains at the system’s
default color for that Color Key.
NOTE
An edge color appears only on
Machine Fonts or Flash Font
characters which have edges.
 3LFNLQJ8S'HSRVLWLQJ&RORU
[ ] 1. Place the mouse cursor over any color on the
Color Palette, then click the left mouse button.
[ ] 2. Move the mouse cursor to either the face or
edge of the Color Key cube, then click the left
button to deposit the color at that location.
The face or edge of the Color Cube for that Color Key
assumes the new color. Any text on the screen that used
the color(s) stored in that Color Key also changes to the
new color.
 5HFDOOLQJ1XPHULF6OLGHU9DOXHV
To recall the numeric HSI values for any Color Key:
• Enter Palette mode, press
COLOR FONT, then the
Color Key where the color is stored.
OR...
• Place the mouse cursor over the color on the Edit
Monitor, then click the left mouse button.