Chyron infinit! series - 11.2.2.3 Bckgrnd (Background)

CHYRON Corporation
Clock & Timer Displays 11-6 Revision D
To reset the Timer:
[ ] 1. Press
R. The following window is displayed.
Figure 11-2. Set Timer WIndow
[ ] 2. The default Time: is 00:00:00. It is not
necessary to change this setting in
Timer Up
mode if starting the count from 00:00:00. If
you want to set a start time for either
Timer Up
or Timer Down:
• Press CLR. Enter a starting time, then
press

.
To reset the Timer while it is running:
[ ] 1. Press
R. The Set Timer window is displayed.
[ ] 2. Press
CLR. Enter a new value, then press

.
The Timer resumes counting at the new value.
 %FNJUQG%DFNJURXQG
NOTE
To activate Bckgrnd Mode, the
system must be equipped with two or
more frame buffers. It is therefore not
available on a MAXINE! system.
Additionally, Bckgrnd Mode is
available only to the Primary User in
an iNFiNiT! Dual User configuration,
and only if two frame buffers are
available to the Primary User.
6HW7LPHU
Time: 00:00:00