iNFiNiT! Family Operation Manual
Revision D 13-13 Flash Font
This concludes the Flash Font tutorial. Further informa-
tion about these features appears later in this section.
)ODVK)RQW:LQGRZ
The parameters for each of the following functions can
be set using the methods described in §13.3. Select or
highlight the item before making any changes.
The
Address Keypad cannot be used to enter negative
values.
)RQW6L]H
Font Size can be set to a height from 6 to 1000 (or what-
ever size is allowed by available system RAM during
conversion) scanlines. Default
Font Size is 10.
Additional
functions
Additional functions are as follows:
• Press
D or select Change Dir to change current
Machine Font directory.
• Press
L or select List to list all Machine Fonts stored in
current directory
•
Convert, and Quit (both described below).
Quit or
Convert
• Press Q or select Quit to exit this menu without convert-
ing a Machine Font.
• Press
C or select Convert to begin the conversion.
Conversion time depends on the specific font size and char-
acteristics, but usually is finished in under a minute.
To Next Page
Loading...